and install the pins into the holes. If you are careful, the tape
can be reused on several silos.
The last silo to be constructed at the end was done using 2” PVC
laminated with .010” styrene [24-25]. To replicate the proto-
type, I cut the styrene into panels seven scale feet in height and
used the same pounce wheel to create vertical rivet lines every
5’ on the panels. A .030” by .030” strip of styrene was wrapped
around the silo between each panel to represent the segmented
construction of the prototype. After the panels were completed,
I added a .040” roof and more of the brass two-pipe railings in
the same manner as the other 10 silos. [24 and 25].
23. This photo shows the completed details of the silos
and base.
23