8. Resistor and LED leads glued to paper every 36 inches.
8
9. Cutting paper every 36 inches.
9
10. Fold over and glue the flags.
10
extend beyond the paper’s edge or you’ll end up with a flag
that was run over by a locomotive. Once the CA has dried, cut
the paper with a sharp razor blade, or X-Acto knife, 18” either
side of the wire [9].
Maintenance flags - 6
7. LED, resistor and trimmed wires.
7
Don’t trim the wires to length, as their height above the grade
will be determined by the depth of the hole you drill to hold
the wire. To hold the wires onto the paper a miniscule amount
of CA glue is all that is needed. Make sure the ACC glue doesn’t
MRH-Dec 2014