28
28. Underside view showing reinforcing strip between
cab sub-base and sill unit.
from .015” brass wire instead. Use either method to install the
air piping on your model.
Figure [31] shows the pilot details. Drill two #52 holes in the
front pilot .175” from the bottom and .460” apart for mounting
the plow. Take one plow from the Details West SD45 detail kit
and file off the MU hose doors. Drill four #80 holes in the top of
the plow, bend two grab irons using .008” brass wire, and glue
them in place. Drill a hole in the plow for the Details West 267
brake hose and glue it in place.
I used Details West 295 for the front MU hoses. These are four-
hose clusters; if you remove the largest hose, it gives you a
three-cluster set of long MU hoses. This is perfect when you
are modeling MU hoses which feed through a plow as on this
model. Glue the MU hoses in place, bend them so they stick
