22
22. Completed long hood right front view.
should line up but the bottoms do not. Drill #80 holes for grab
iron on the front of the right sub base.
Moving on to assembly of the short hood, select the left side
with no brake wheel or hand brake. Build up the inside of the
front of the nose with .020”x.080” styrene strip as seen in [24].
Once the glue dries, file a notch in the top front of the short
hood that is .250” high and .200” wide. The bottom of the
notch should be tapered, and the top curved as seen in [23
and 25]. At this point I also removed the classification lights by
applying putty and sanding until the area was smooth.
Drill a #64 hole in the top of the short hood that is .300” from
the rear and .170” from the left side, install vent #13 from the
Cannon short hood kit. Drill all the grab iron holes with a #80 bit.
