Cannon generator compartment door on the right side of the
hood .120” from the bottom of the hood and .360” from the
front [18].
Plano 14651 lift rings are installed on the dynamic hatch and
Plano 14652 lift rings on the radiator compartment, turbo
hatch, and inertial filter hatch. Bend the curved grab iron
behind the rear radiator fan using .008” brass wire. I added the
sand filler hatch and lift tabs on the rear of the hood from the
Plano 14771 winterization hatch screen. I used lift tabs from
Sunrise Models, but these parts are no longer available. A #76
hole was drilled where I previously plugged the hole for the
handbrake wheel. Glue a short piece of .015” wire in the hole;
use this as a mounting pin to attach the hand brake wheel from
the Cannon short hood kit.
18. Electrical cabinet/clean air room door.
18
