A piece of blue painters’ tape holds the LED in place by its
wires in the top of the shell. Slide the LED into place and
observe that it is positioned to shine out through the lens.
Then put a drop of Canopy Glue to hold it in place, as in figure
13. Set it aside to dry for at least a few hours before working
on the shell again.
3.3 Fix Cab Floor
Several of the locos I did in this batch had had DCC decoders
installed previously. The cab detail floor had been cut away to
provide a place for a very small decoder to reside. I fixed the
cab floor by cutting a piece of 0.02-inch thick plastic (black,
in this case) to fit over the hole. I glued it in place and spray
painted it with Krylon gray primer. You will only need to do this
if your loco has had the integrity of the cab details damaged in
a prior installation. Set it aside to let the paint dry. We won’t
use it until the final assembly. See figure 14.
4.0 Machine frame
The key to this installation is to get enough room in the frame
for the decoder, speaker and wires. This requires a bit of fancy
milling. George at TVW Miniatures
designed this version and offers frame machining ser-
vices. Even though I have a mill, I had him do the machining.
Kato no longer has stock of the frames, so if you mess up your
frame, you may never get your loco back running.
If you are going to machine them yourself, there are dimen-
sions on my web site
.
