The Tool Shed - 4
5: When scribing thicker materials such as this .040" sheet of
styrene, extend one leg of the dividers as shown in this photo.
That makes it easier to follow the edge of the sheet of styrene.
5
to be cut to a larger sheet of thick (such as .040″) styrene;
as the center leg of the compass pushes through the thin
material it will stay in place via the underlying material.
Large round discs are needed when scratchbuilding water and
fuel tanks. I typically use .040″ styrene for the tops and bot-
toms of such tanks and the regular needle doesn’t work that
well (6) since it tends to cut a V-shaped slot. In those cases I
will grind the needle to a chisel shape as shown in Photo 7.
Note that most compass needles are double-ended so that
you can grind one end and still have a pointed needle end for
transferring dimensions. The needle is positioned in the com-
pass with the cutting edge closest to the center of the circle.
Again, make a number of passes and then either snap the
styrene piece out, or finish up with a hobby knife after
MRH-Oct 2013
