23
23. The corner grab installed on one half of the roof.
Once the car weights are added, move on to the roof assem-
bly. The roof is in three parts. The instructions call for adding
the roof hatches next. This would make installing the corner
grabs difficult, so I did them first. Use the same method, as the
grab irons on the sides and ends, cut one end of the roof grab
short, insert the long end, mark where the short ends falls, and
drill. Adjust the grab as necessary. Then insert the long end of
the grab and add the eye bolt for the center stand. Insert the
eye bolt, then insert the short end. Apply CA from underneath
and trim the protruding ends for a flat surface. You can see the
completed grab, with the ice hatch installed in [23].
Roof and reinforcements
Remember that the car is going to be handled from time to
time. There are roof supports in the kit but they do not pro-
vide much help in bracing the sides. It helps to brace the sides
