9: These four photos show how you can easily make a template
for cutting a sheet of clear styrene to make window glass for a
window casting. There are pencil marks on the paper for the hor-
izontal and vertical extents of the window opening. In this view,
the sliding triangle is aligned with the bottom pencil mark.
9
“parallel line” technique discussed above. As shown in Photo 8,
hold the pair of triangles together and align the sliding triangle
to the base line. Then, while holding the fixed triangle, turn the
sliding triangle 90
o
degrees as shown and you have a 90
o
angle.
Here is a practical application using two triangles shown in
Photo 8. Let’s assume that you want to cut some clear styrene
to fit inside a cast styrene window. You can easily make a win-
dow tracing template to make this task very easy.
Start by measuring the width and height of the opening in the
window casting and transfer those measurements to a piece
of paper with pencil marks. Envision the window casting on
the paper and make the marks roughly in the middle of the
two sides and middle of the top and bottom. The marks on the
“sides” should be equal to the width of the “glass” for the win-
dow opening, while the top and bottom marks should be equal
to the height of the glass.
