Page 234 - 39. MRH13-05-May2013-P

38
38: It’s on to the vertical top portion of the roof
ribs. I measured in 4” and drew a line parallel with
each side. This line marks the limits of the vertical
“top rib” that sits on top of the 1” x 6”. For this top
rib I cut 2” x 2” stock. I also cut these long since
I would be trimming them in place. These were
centered over the 1” x 6” pieces that form the
base of the ribs.
Again I cemented one end into place and let it
dry. Once it had set, I pulled the stock down and
worked my way across the roof to the other side. I
just used my eye and a pair of tweezers to center
these. It really worked out well.
Once all of the ribs had dried, I trimmed them to
the 4” line that I had previously marked. When
trimming the pieces I cut them down vertically.
This produces the slight angle as seen in the
photo of Erie 72893.
STEP 8A: Adding the Major Ribs Continued ...
The Erie RR Boxcars Part 2 - 7
The 1" x 6"ribs continue
over the sides of the roof.
These pieces are tucked
up under the roof ribs.
Once everyting is dry I
trim to fit
index contents
MRH-May 2013