DCC Impulses Column - 4
3. Gasket shown with a 28 mm round speaker.
3
Slide the strip out until the freshly cut side is lined up with the
1 1/2 inch mark and make a second cut. I now have a piece
with three square sides that is as long as the blade in the
Chopper II and a bit wider than my final dimension.
Use the inside measurement side of the calipers to get the
width of the shell and lock them to it.
Use the extension rod portion of the calipers to adjust the
spacing between the blade (be careful, it is designed to cut-
very sharp) and the fence.
Cut the fourth side of the styrene strip by placing the factory
side against the fence you just positioned. This strip is now
square and should slip into the loco shell easily.
MRH-Aug 2014
