11. This side view shows the power connections and
on/off switch on the right. The track is connected to
the two blue terminals on the left. The cut section of
the block is connected to the single green terminal.
11
back a session only after pressing the START button. If set to
DISABLE the recording will be played back over and over.
BLOCK
– a pushbutton switch that activates the block sync
relay. If you are using a stop block, press this button as the
train approaches the stop block and it will come to a complete
stop, re-synchronizing its operation. Remember to keep the
power on for a few seconds to allow the train to enter the stop
block during playback, should it be slightly out of sync.
