decoder at the same time. You then tell it which address you
want to use and it will set CV 29 accordingly.
Here we go, alphabetically.
Digitrax
Digitrax reserves address zero for running locos without decod-
ers. While this mode is not recommended, it is still there.
No matter how you select an address on a Digitrax throttle,
if it is between 1 and 127, the system will speak to it as a
short address. You cannot override this behavior. Similarly,
an address between 128 and 9983 will be spoken to as a long
address. Addresses from 9984 to 10239 are not accessible.
4: DecoderPro screen shot for the loco from figure 2. This
is the basic panel setting short and long addresses and
selecting the long (extended) address. The loco direction is
reversed, as this is an Aristo-Craft garden loco, where the
direction of motion is reversed from the NMRA standards.
4
