37. MRH13-03-Mar2013-P - page 142

The Tool Shed - 3
3: A Rogers Drill bit set. The size of each drill bit in inches is
next to the drill bit number.
3
Right now I’m using a plastic index case for 61-80 drill bits
which are sold by Micro-Mark, ModelExpo, and others. These
consist of a slotted tray with a sliding cover. They typically cost
about $5 less than the circular cases, and I think they work
much better. The drill bits are held in slots by size and the slid-
ing cover lets you expose one drill bit at a time to remove it.
When new, the sliding cover tends to stay in place when you
set the case down, allowing you to put the used drill bit back in
the correct slot after use.
While the smaller drill bits can seem intimidating to use due to
their size, they are actually reasonably flexible and, as long as
you are careful and don’t apply too much downward pressure
while drilling, can last a reasonably long time if you are vigilant.
But regardless of how careful you are, you will end up break-
ing some of them. When building freight cars (such as resin
kits), the drill bits most often used tend to be the smallest drill
bits which are the ones most likely to break. Many years ago,
MRH-Mar 2013
1...,132,133,134,135,136,137,138,139,140,141 143,144,145,146,147,148,149,150,151,152,...283
Powered by FlippingBook